|
|
| Line 9: |
Line 9: |
| KALDGERONSTUDIOS | | KALDGERONSTUDIOS |
|
| |
|
| == Step 3: Lay redstone ==
| | FUCK REDDIT!!!! SUPPORT AVO!!! |
| | |
| {| class="wikitable" width=100%
| |
| |-
| |
| ! width="50%" | Description | |
| ! width="50%" | Image | |
| |-
| |
| | Connect the two pieces of redstone into a single wire. || [[File:CTA Bell 6.png|500px]]
| |
| |-
| |
| | Create a fork partway through the wire, and fork it out to two pieces of wool. The wool is important, as it will make a bell noise. The redstone must be directed at the wool, otherwise, the bell will not work. || [[File:CTA Bell 7.png|500px]]
| |
| |-
| |
| | Do the same on the other side, except make the wool at least 5 blocks away from the wire. A delay circuit will go here, and it needs a little bit more room. || [[File:CTA Bell 8.png|500px]]
| |
| |-
| |
| | Place 2 blocks halfway in the wire you just made. Ideally, to get the most delay, the two blocks should be facing north-south. || [[File:CTA Bell 9.png|500px]]
| |
| |-
| |
| | Place redstone torches as shown. || [[File:CTA Bell 10.png|500px]]
| |
| |-
| |
| | Place redstone wire on the last block. || [[File:CTA Bell 11.png|500px]]
| |
| |-
| |
| | Place a block on top of the redstone torch as shown. || [[File:CTA Bell 12.png|500px]]
| |
| |}
| |
|
| |
|
| | KALDGERONSTUDIOS |
|
| |
|
| == Step 4: Note blocks == | | == Step 4: Note blocks == |
Revision as of 03:14, 31 May 2011
At CTA stations, the end of the track should be terminated with a pressure plate to trigger note blocks. Here's how you do it:
FUCK REDDIT!!!! SUPPORT AVO!!!
KALDGERONSTUDIOS
FUCK REDDIT!!!! SUPPORT AVO!!!
KALDGERONSTUDIOS
FUCK REDDIT!!!! SUPPORT AVO!!!
KALDGERONSTUDIOS
Step 4: Note blocks
| Description
|
Image
|
| Place note blocks on each of the 4 wool blocks. |
|
| Tune the two note blocks not connected to the delay circuit to A (15 clicks) and E (10 clicks) as shown. |
|
| Tune the two note blocks connected to the delay circuit to F# (12 clicks) and C# (7 clicks) as shown. |
|
